Task Manager

For my final project, I decided to use the Arduino as a controller for a computer game made using Processing. The game requires the player to constantly be managing both of the lines that change direction based on the 2 switches and both of the balls that bounce based on the 2 push buttons. If any of the lines or balls reach either the top or bottom of the game screen, the game is over. In terms of wiring, I tried my best to keep it extra clean and decided to hide them by simply covering them with paper. Thankfully, the breadboard is small enough that it can be held without feeling clunky or unlike a really game controller.




Comments

Post a Comment

Popular posts from this blog

Exercise Music Shirt

Image
For my second project, I made a wearable in the form of a shirt that plays music whenever the user moves/exercises. The shirt features a FLORA accelerometer sensor that has been sewn to the chest area. The sensor is then connected to the duct taped breadboard which holds an Arduino Nano. The Nano also has a speaker connected to it. Finally, to supply power, I used a 9 volt battery with a connector for ground and power. I was going to add some sort of pouch, or at least a switch to turn on and off the device, preventing the need the plug and unplug the battery for every use, but that was more of a stretch goal. Also, as mentioned before, I attempted to sew, but mostly failed and used lots of tape. Although that was also because I could not see a way to sew the whole breadboard securely. The only successfully sewn portion is the sensor, mostly because it is meant to be sewn through its holes. In terms of the software, I used the toneAC library for better sound control than the native Ard
Read more

Lentils and Jello Maze Game

Image
The idea is a physical maze game where enough lentils need to reach the end to weigh down the pressure sensor and win. But, along the way, there are Jello obstacles that would stop the lentils that the player must adjust the maze for. The player can physically move the maze pieces until they find a path that perfectly sends the lentils to the end uninhibited by the Jello. This idea comes from mazes often found in kids museums where this is the same idea, except usually with balls and other obstacles rather than lentils and Jello.
Read more

LED on Fabric

Image
As this was the first time I was tasked with using loose wires and an LED detached from the breadboard, I was worried going into this. However, it turned out fine. I definitely need to solder the connections for the future, but as a rough test, this was successful. I thought the connection was going to be a lot more finicky, but thankfully my wiring job was strong enough for the LED to work. This has made my expectations for the wearable project a lot less stressful.
Read more